A silent, vibration-free way to keep your dog’s teeth and gums clean at home.
What is Mira-Pet Ultrasound?
Mira-Pet is an ultrasonic toothbrush designed specifically for dogs. Instead of spinning or oscillating bristles, it uses ultrasound to clean along the teeth and gumline, so it’s quiet and doesn’t buzz or vibrate in your dog’s mouth. That makes it far easier for nervous or sensitive dogs to accept.
You can completely turn off the vibration and sound knowing the ultrasound is still actively operating.
How does it work?
The brush produces around 60 - 80 million tiny air oscillations per minute (ultrasound). Combined with Mirapet dog-safe ultrasound toothpaste gel, this creates microscopic bubbles that help break down the bacteria in plaque, including in areas a normal toothbrush struggles to reach, like the gumline and between the teeth.
Because the cleaning comes from the ultrasound and not from scrubbing, you only need to guide the brush gently along the teeth. Light contact is all it takes. You don't need to scrub.
What results to expect
- Fresher breath as bacteria levels reduce down.
- Less plaque build-up when used consistently, which helps slow the formation of tartar.
- Decrease of tartar build-up
- Healthier-looking gums over time, with less redness.
- A dog that accepts brushing, thanks to the quiet, gentle action.
How to use
- Charge and prepare. Fully charge the brush with the USB cable and attach the brush head that suits your dog’s mouth.
- Introduce it slowly. Let your dog sniff the brush while it’s switched off, with treats and praise. Next, let them taste a little toothpaste gel.
- Apply toothpaste gel. Put a small amount of ultrasound toothpaste gel on the brush head. Add water, it is required to create the nano bubbles for ultrasound to penetrate tartar.
- Switch on and glide. Gently guide the head along the outer surfaces of the teeth and gumline, a few teeth at a time, working across the top and bottom, left and right.
- Keep it moving. Use light pressure and slow, steady passes. Aim for about 45–60 seconds in total per tooth. Take breaks as per your dogs acceptance level.
- Finish positively. Reward your dog, then rinse the brush head while ultrasound is on under running warm water and let it dry fully. You can also sanitise with Chlorhexidine Rinse.
Quick tips
- Start small. Even a few teeth on day one is a win. Build up over a week or two.
- Pick a calm moment, like after a walk, when your dog is relaxed.
- Use ultrasound toothpaste gel. The ultrasound works together with the gel, so regular toothpaste isn’t a substitute.
- Always add water
- Light touch. You don’t need to press or scrub. Let the ultrasound do the work.
- Be consistent. Regular short sessions work better than the occasional long one.
- Focus on the outer surfaces, especially the back teeth, where tartar builds up most.
- Stop and try again later if your dog becomes stressed. Keep it positive.
Changing brush heads
Brush heads wear over time and collect bacteria, so replace them regularly. As a general guide, change the head about every 3 months, or sooner if the bristles look worn or splayed.
- Switch the brush off and make sure it isn’t running.
- Turn brushead carefully clockwise and gently pull the old head straight off the brush shaft.
- Push the new head on firmly and turn back to lock in.
- Test it. Switch on briefly to check the head is secure before use.
Choose the head that suits your dog: smaller single heads for small mouths and precise areas, and the larger multi-sided head to speed up cleaning on bigger dogs. Always use heads made for Mira-Pet.
Complementary products
Mira-Pet works best as part of an everyday routine. These products support your dog’s oral care alongside it: